LPG Discussion Forum

Hi

Does anyone know the manual calibration settings/piston depth for valtek type 30 calibration?

I have a valtek compatible micrometer, but dont know the standard depth for the piston.

I was planning to use repair kits on all 6 injectors tomorrow but bit apprehensive without knowing the settings, hope someone can help?

Thanks

Unless these are ten-year old, stroke isn't adjustable anyway?
Measure before you start, and take an average?
It's much more important to have them all alike, than set to any absolute value.

Thanks for the reply!

Ok i maybe wrong abt piston stroke.. maybe should say depth..

Anyway, ok il take the average thanks for the advice.

Any tips as to what to look for when deciding weather i need more or less depth?

thanks

Not sure what you mean by depth. What are you expecting to reassemble differently than it came apart?